Swerve Drive Prototype

By Abhi and Christian

Task: Build a Swerve Drive base

Over the past week, I worked with Christian and another member of Imperial to prototype a drive train. Due to the limited resources. we decided to use Tetrix parts since we had an abundance of those. We decided to make the swerve such that a servo would turn a swerve module and the motors would be attached directly to the wheels.

Immediately we noticed it was very feeble. The servos were working very hard to turn the heavy module and the motors had trouble staying aligned. Also, programming the chassis was also a challenge. After experimenting further, the base even broke. This was a moment of realization. Not only was swerve expensive and complicated, we also would need to replace a module really quickly at competition which needed more resources and an immaculate design. With all these considerations, I ultimately decided that swerve wasn't worth it to use as a drive chassis at this time.

Next Steps

Consider and prototype other chassis designs until Rover Ruckus begins.